Getting Low-E Glass Preheating Right (Especially When It’s Wide) When you’re dealing with wide-format Low-E glass, the biggest headache...

Solving the “Cold Spot” Problem in Long Glass Tunnel Kilns Most infrared lamps are short—usually just a few hundred millimeters. But if...

Stop the Chipping: Why We Preheat Glass with IR Let’s be honest: glass is a pain to work with. It’s brittle. When you hit a cold sheet of...

Why Consistent IR Lamps Stop Your Glass Batches From Going Rogue Glass annealing is all about precision. But if you’ve done this for a while,...

Cutting through ultra-thick borosilicate glass is basically a wrestling match. If you just try to force a cutting wheel through that kind of hardness...

Getting Silk-Screening and Tempering Right (Without Burning Your Ink) Here’s the struggle when you’re trying to silk-screen and temper glass in one...

Stop Wrestling With Your IR Lamps Buying a single medium-wave infrared lamp is the easy part. Anyone can order a tube. But actually getting that lamp...

Getting the Heat Right for Long Glass Tube Tunnel Kilns If you’re sealing glass tubes in a tunnel kiln, you know the struggle. You need the...

Getting the Heat Just Right for Glass Score Lines If you’ve ever dealt with glass that doesn’t break clean—or worse, shatters because of...

Dealing with Extra-Thick Glass? Try Pre-heating. If you’ve ever tried to score a piece of ultra-thick glass, you know the struggle. It’s a...

Introduction We built this shortwave infrared (SWIR) drying lamp for one very specific job: curing nano-coatings on glass. Let’s be...

On the line, a single hot spot during preheating can turn a pane into a handful of unpredictable shards. Yield drops. Safety takes a hit. We built...

Out on the line, glass tube annealing isn’t a “nice-to-have.” It’s the last checkpoint before the part either ships or ends up in the scrap bin. If...

On the insulating glass line, edge sealant drying is the quiet choke point that sets your throughput and scrap rate. If the lamp can’t keep up,...

On the spectacle lens line, annealing is where you either make yield or lose it. If the thermal profile is off, you’re left with residual stress—and...